Sub-THz wireless transmission based on graphene-integrated optoelectronic mixer.

Optoelectronics is a valuable solution to scale up wireless links frequency to sub-THz in the next generation antenna systems and networks. Here, we propose a low-power consumption, small footprint building block for 6 G and 5 G new radio wireless transmission allowing broadband capacity (e.g., 10-100 Gb/s per link and beyond). We demonstrate a wireless datalink based on graphene, reaching setup limited sub-THz carrier frequency and multi-Gbit/s data rate. Our device consists of a graphene-based integrated optoelectronic mixer capable of mixing an optically generated reference oscillator approaching 100 GHz, with a baseband electrical signal. We report >96 GHz optoelectronic bandwidth and -44 dB upconversion efficiency with a footprint significantly smaller than those of state-of-the-art photonic transmitters (i.e., <0.1 mm2). These results are enabled by an integrated-photonic technology based on wafer-scale high-mobility graphene and pave the way towards the development of optoelectronics-based arrayed-antennas for millimeter-wave technology.

Scalable High-Mobility Graphene/hBN Heterostructures.

Graphene-hexagonal boron nitride (hBN) scalable heterostructures are pivotal for the development of graphene-based high-tech applications. In this work, we demonstrate the realization of high-quality graphene-hBN heterostructures entirely obtained with scalable approaches. hBN continuous films were grown via ion beam-assisted physical vapor deposition directly on commercially available SiO2/Si and used as receiving substrates for graphene single-crystal matrixes grown by chemical vapor deposition on copper. The structural, chemical, and electronic properties of the heterostructure were investigated by atomic force microscopy, Raman spectroscopy, and electrical transport measurements. We demonstrate graphene carrier mobilities exceeding 10,000 cm2/Vs in ambient conditions, 30% higher than those directly measured on SiO2/Si. We prove the scalability of our approach by measuring more than 100 transfer length method devices over a centimeter scale, which present an average carrier mobility of 7500 ± 850 cm2/Vs. The reported high-quality all-scalable heterostructures are of relevance for the development of graphene-based high-performing electronic and optoelectronic applications.

Phonon-mediated room-temperature quantum Hall transport in graphene.

The quantum Hall (QH) effect in two-dimensional electron systems (2DESs) is conventionally observed at liquid-helium temperatures, where lattice vibrations are strongly suppressed and bulk carrier scattering is dominated by disorder. However, due to large Landau level (LL) separation (~2000 K at B = 30 T), graphene can support the QH effect up to room temperature (RT), concomitant with a non-negligible population of acoustic phonons with a wave-vector commensurate to the inverse electronic magnetic length. Here, we demonstrate that graphene encapsulated in hexagonal boron nitride (hBN) realizes a novel transport regime, where dissipation in the QH phase is governed predominantly by electron-phonon scattering. Investigating thermally-activated transport at filling factor 2 up to RT in an ensemble of back-gated devices, we show that the high B-field behaviour correlates with their zero B-field transport mobility. By this means, we extend the well-accepted notion of phonon-limited resistivity in ultra-clean graphene to a hitherto unexplored high-field realm.

Moiré-Induced Transport in CVD-Based Small-Angle Twisted Bilayer Graphene.

To realize the applicative potential of 2D twistronic devices, scalable synthesis and assembly techniques need to meet stringent requirements in terms of interface cleanness and twist-angle homogeneity. Here, we show that small-angle twisted bilayer graphene assembled from separated CVD-grown graphene single-crystals can ensure high-quality transport properties, determined by a device-scale-uniform moiré potential. Via low-temperature dual-gated magnetotransport, we demonstrate the hallmarks of a 2.4°-twisted superlattice, including tunable regimes of interlayer coupling, reduced Fermi velocity, large interlayer capacitance, and density-independent Brown-Zak oscillations. The observation of these moiré-induced electrical transport features establishes CVD-based twisted bilayer graphene as an alternative to "tear-and-stack" exfoliated flakes for fundamental studies, while serving as a proof-of-concept for future large-scale assembly.

Wafer-Scale Integration of Graphene-Based Photonic Devices.

Graphene and related materials can lead to disruptive advances in next-generation photonics and optoelectronics. The challenge is to devise growth, transfer and fabrication protocols providing high (≥5000 cm2 V-1 s-1) mobility devices with reliable performance at the wafer scale. Here, we present a flow for the integration of graphene in photonics circuits. This relies on chemical vapor deposition (CVD) of single layer graphene (SLG) matrices comprising up to ∼12000 individual single crystals, grown to match the geometrical configuration of the devices in the photonic circuit. This is followed by a transfer approach which guarantees coverage over ∼80% of the device area, and integrity for up to 150 mm wafers, with room temperature mobility ∼5000 cm2 V-1 s-1. We use this process flow to demonstrate double SLG electro-absorption modulators with modulation efficiency ∼0.25, 0.45, 0.75, 1 dB V-1 for device lengths ∼30, 60, 90, 120 µm. The data rate is up to 20 Gbps. Encapsulation with single-layer hexagonal boron nitride (hBN) is used to protect SLG during plasma-enhanced CVD of Si3N4, ensuring reproducible device performance. The processes are compatible with full automation. This paves the way for large scale production of graphene-based photonic devices.

Synthesis of Large-Scale Monolayer 1T'-MoTe2 and Its Stabilization via Scalable hBN Encapsulation.

Out of the different structural phases of molybdenum ditelluride (MoTe2), the distorted octahedral 1T' possesses great interest for fundamental physics and is a promising candidate for the implementation of innovative devices such as topological transistors. Indeed, 1T'-MoTe2 is a semimetal with superconductivity, which has been predicted to be a Weyl semimetal and a quantum spin Hall insulator in bulk and monolayer form, respectively. Large instability of monolayer 1T'-MoTe2 in environmental conditions, however, has made its investigation extremely challenging so far. In this work, we demonstrate homogeneous growth of large single-crystal (up to 500 µm) monolayer 1T'-MoTe2 via chemical vapor deposition (CVD) and its stabilization in air with a scalable encapsulation approach. The encapsulant is obtained by electrochemically delaminating CVD hexagonal boron nitride (hBN) from copper foil, and it is applied on the freshly grown 1T'-MoTe2 via a top-down dry lamination step. The structural and electrical properties of encapsulated 1T'-MoTe2 have been monitored over several months to assess the degree of degradation of the material. We find that when encapsulated with hBN, the lifetime of monolayer 1T'-MoTe2 successfully increases from a few minutes to more than a month. Furthermore, the encapsulated monolayer can be subjected to transfer, device processing, and heating and cooling cycles without degradation of its properties. The potential of this scalable heterostack is confirmed by the observation of signatures of low-temperature phase transition in monolayer 1T'-MoTe2 by both Raman spectroscopy and electrical measurements. The growth and encapsulation methods reported in this work can be employed for further fundamental studies of this enticing material as well as facilitate the technological development of monolayer 1T'-MoTe2.

Ultrafast, Zero-Bias, Graphene Photodetectors with Polymeric Gate Dielectric on Passive Photonic Waveguides.

We report compact, scalable, high-performance, waveguide integrated graphene-based photodetectors (GPDs) for telecom and datacom applications, not affected by dark current. To exploit the photothermoelectric (PTE) effect, our devices rely on a graphene/polymer/graphene stack with static top split gates. The polymeric dielectric, poly(vinyl alcohol) (PVA), allows us to preserve graphene quality and to generate a controllable p-n junction. Both graphene layers are fabricated using aligned single-crystal graphene arrays grown by chemical vapor deposition. The use of PVA yields a low charge inhomogeneity ∼8 × 1010 cm-2 at the charge neutrality point, and a large Seebeck coefficient ∼140 µV K-1, enhancing the PTE effect. Our devices are the fastest GPDs operating with zero dark current, showing a flat frequency response up to 67 GHz without roll-off. This performance is achieved on a passive, low-cost, photonic platform, and does not rely on nanoscale plasmonic structures. This, combined with scalability and ease of integration, makes our GPDs a promising building block for next-generation optical communication devices.

30°-Twisted Bilayer Graphene Quasicrystals from Chemical Vapor Deposition.

The artificial stacking of atomically thin crystals suffers from intrinsic limitations in terms of control and reproducibility of the relative orientation of exfoliated flakes. This drawback is particularly severe when the properties of the system critically depends on the twist angle, as in the case of the dodecagonal quasicrystal formed by two graphene layers rotated by 30°. Here we show that large-area 30°-rotated bilayer graphene can be grown deterministically by chemical vapor deposition on Cu, eliminating the need of artificial assembly. The quasicrystals are easily transferred to arbitrary substrates and integrated in high-quality hexagonal boron nitride-encapsulated heterostructures, which we process into dual-gated devices exhibiting carrier mobility up to 105 cm2/(V s). From low-temperature magnetotransport, we find that the graphene quasicrystals effectively behave as uncoupled graphene layers, showing 8-fold degenerate quantum Hall states. This result indicates that the Dirac cones replica detected by previous photoemission experiments do not contribute to the electrical transport.

High-speed double layer graphene electro-absorption modulator on SOI waveguide.

We report on a C-band double layer graphene electro-absorption modulator on a passive SOI platform showing 29GHz 3dB-bandwith and NRZ eye-diagrams extinction ratios ranging from 1.7 dB at 10 Gb/s to 1.3 dB at 50 Gb/s. Such high modulation speed is achieved thanks to the quality of the CVD pre-patterned single crystal growth and transfer on wafer method that permitted the integration of high-quality scalable graphene and low contact resistance. By demonstrating this high-speed CVD graphene EAM modulator integrated on Si photonics and the scalable approach, we are confident that graphene can satisfy the main requirements to be a competitive technology for photonics.

High-temperature quantum oscillations of the Hall resistance in bulk Bi2Se3.

Helically spin-polarized Dirac fermions (HSDF) in protected topological surface states (TSS) are of high interest as a new state of quantum matter. In three-dimensional (3D) materials with TSS, electronic bulk states often mask the transport properties of HSDF. Recently, the high-field Hall resistance and low-field magnetoresistance indicate that the TSS may coexist with a layered two-dimensional electronic system (2DES). Here, we demonstrate quantum oscillations of the Hall resistance at temperatures up to 50 K in nominally undoped bulk Bi2Se3 with a high electron density n of about 2·1019 cm-3. From the angular and temperature dependence of the Hall resistance and the Shubnikov-de Haas oscillations we identify 3D and 2D contributions to transport. Angular resolved photoemission spectroscopy proves the existence of TSS. We present a model for Bi2Se3 and suggest that the coexistence of TSS and 2D layered transport stabilizes the quantum oscillations of the Hall resistance.

High electron mobility, quantum Hall effect and anomalous optical response in atomically thin InSe.

A decade of intense research on two-dimensional (2D) atomic crystals has revealed that their properties can differ greatly from those of the parent compound. These differences are governed by changes in the band structure due to quantum confinement and are most profound if the underlying lattice symmetry changes. Here we report a high-quality 2D electron gas in few-layer InSe encapsulated in hexagonal boron nitride under an inert atmosphere. Carrier mobilities are found to exceed 103 cm2 V-1 s-1 and 104 cm2 V-1 s-1 at room and liquid-helium temperatures, respectively, allowing the observation of the fully developed quantum Hall effect. The conduction electrons occupy a single 2D subband and have a small effective mass. Photoluminescence spectroscopy reveals that the bandgap increases by more than 0.5 eV with decreasing the thickness from bulk to bilayer InSe. The band-edge optical response vanishes in monolayer InSe, which is attributed to the monolayer's mirror-plane symmetry. Encapsulated 2D InSe expands the family of graphene-like semiconductors and, in terms of quality, is competitive with atomically thin dichalcogenides and black phosphorus.

Synergic Exfoliation of Graphene with Organic Molecules and Inorganic Ions for the Electrochemical Production of Flexible Electrodes.

A facile and efficient method based on electrochemistry for the production of graphene-based materials for electronics is demonstrated. Uncharged acetonitrile molecules are intercalated in graphite by electrochemical treatment, owing to the synergic action of perchlorate ions dissolved in acetonitrile. Then, acetonitrile molecules are decomposed with microwave irradiation, which causes gas production and rapid graphite exfoliation, with an increase in the graphite volume of up to 600 %. Upon further processing and purification, highly dispersible nanosheets are obtained that can be processed into thin layers by roll-to-roll transfer or into thicker electrodes with excellent capacitance stability upon extensive charging/discharging cycles. The good exfoliation yield (>50 % of monolayers), minimal oxidation damage and good electrochemical stability of the nanosheets obtained were confirmed by scanning force and electron microscopy, as well as Raman spectroscopy and galvanostatic analyses.